Multi Raspberry PI & RTL-SDR Application Mother Board for Raspberry Pi B+ / Pi 2 / Pi 3

Inexpensive Multi RTL-SDR Application Mother Board for Raspberry Pi B+ / Pi 2 / Pi 3 applications. Designed in the U.S.A. by WyJen Technologies. The mother board uses a dual USB port for two RTL-SDRs with but the bottom RTL-SDR configured to use a dedicated power supply separate from the Raspberry Pi. Unlike the typical host device, the dedicated Mother Board's power source allows the RTL-SDR (and Raspberry Pi) to run continually without overloading the Raspberry Pi's standard USB supply which may cause the RTL-SDR to be interrupted. One LED is provided on the mother board for status. Popular applications are:

1. TCP Raspberry Client for sending RTL-SDR receiver data to remote server

2. LTE Cell Scanner

3. FM Receiver for multiple frequencies

4. GPS Receiver

5. ADSB Receiver

   
   

   The package comes with the following items (See Figures 1 & 2 below):
   

1. Eight Screws and four standoffs for attaching a /Raspberry PI +/PI 2 / PI 3 to the PCB mother board
   
2. Harness cable with 2 pin (2.54mm) connector jack to micro USB. The harness connects the mother board power power supply to the raspberry micro USB power supply connector
   
3. Three Harness cables from PCB USB connectors to selected three Raspberry Pi USBs
   
4. One 0.5 PPM WyJen RTL2832U/R820T RTL-SDR mother board with antenna
   
5. PCB Power Supply, 100-240V AC 50/60Hz, Output 5V/2A DC with 2.5*0.7mm Male DC Plug
   
6. 6. One WyJen Technologies Multi RTL-SDR Micro PC Application Mother Board, P/N WY-PCB106122-1
   
7. One WyJen Technologies Multi RTL-SDR Micro PC Application Mother Board (106mm x 118mm x 18mm = WxLxH), P/N WY-PCB106122-1
   

Note: The Raspberry Pi computer is not included!

https://youtu.be/OEa_24F3Jqs

UserGuide Archive:

http://wyjen.com/datasheets/WY-SDRWAVE-BPCB-Raspberry-RTL-SDR-Motherboard_Datasheet.pdf