Raspberry Pi B+ / Pi 2 / Pi 3 Configuration: Aluminum Housing Configured for the Raspberry Pi B+ / Pi 2 / Pi 3 Micro-Computer

Give your single board computer, Raspberry Pi B+ / Pi 2 / Pi 3 integrative RTL2832U/R820T application that professional product appearance and look all inside one aluminum noise resistant case. Designed by WyJen Technologies & RTL-SDR-Wave, this case protects your Raspberry mini-computer from damage and looks great in your modern/designer apartment! The design allows your application to use two RTL Software Defined Radios (SDRs) while protecting it from noisy electro-magnetic interference (EMI). The aluminum housing design houses a custom mother board to bring out four USB ports for your application. The mother board can be customized for your application. The current design brings out two SDR MCX connector ports for antenna reception. Two LEDs, one power and one status, are provided on the mother board.

Comes with the following:

1. Aluminum Housing with SDR-WAVE logo

2. Front Plate with four USB ports and HDMI port

3. Rear Plate with two MCX inputs, one dual LED hole, and 5V/2A jack hole

4. 8 Screws for attaching front and back plates to housing

5. 8 Screws and 4 standoffs for attaching the Raspberry PI +/PI 2 / PI 3 to the mother board

6. Harness cable with 2 pin 2.54mm connector jack and 2A micro USB connector. The harness connects the mother board input power via a 2 pin 2.54mm plug to the Raspberry Pi B+/P1 2/Pi 3 power supply.

7. Two harness cables, each with 5 pin 2.54mm jack and male USB Type A connector to two of USBs on the Raspberry Pi B+/P1 2/Pi 3

8. One 0.5 PPM WyJen RTL2832U/R820T RTL-SDR mother board with antenna

9. Power Supply, 100-240V AC 50/60Hz, Output 5V/2A DC with 2.5*0.7mm Male DC Plug

10. 30cm male HDMI Cable to female HDMI

Note: Raspberry computer is not included!

Demo: