ODROID C1+/C2 Configuration:  RTL2832U/R820T SDR uPC Multi-Application W/ Aluminum Housing for ODROID C1+/C2

Give your single board computer, ODROID C1+/C2 application that professional product appearance and look using an aluminum noise resistant case. Designed by WyJen Technologies & RTL-SDR-Wave, this case protects your ODROID mini-computer from damage and looks great in your modern/designer apartment! The design allows your application to use two RTL Software Defined Radios (SDRs) while protecting it from noisy electro-magnetic interference (EMI).  The aluminum housing design houses a custom mother board to bring out four USB ports for your application.  The mother board can be customized for your application.  The current design brings out two SDR MCX connector ports for antenna reception.  Two LEDs, one power and one status, are provided on the mother board.

Comes with the following:

1.  Aluminum Housing with SDR-WAVE logo

2.  Front Plate with four USB ports

3.  Rear Plate with one MCX input, one dual LED hole, and 5V/2A jack hole

4.  8 Screws for attaching front and back plates to housing

5.  8 Screws and 4 standoffs for attaching the ODROID C1+/ C2 to the mother board

6.  Harness cable with 2 pin 2.54mm connector jack and 2.5 mm/.8mm DC Plug, 2A.  The harness connects the mother board power power supply to the ODROID C1+' DC 2.5x0.8mm 5V/2A jack.

7.  Harness cable for USB connector to two of the ODROID C1+/ C2 four USBs

8.  Harness Cable that maps ODROID's 40 pin connector to the mother board's status LEDs

9.  One 0.5 PPM WyJen RTL2832U/R820T RTL-SDR mother board with antenna

10.  Power Supply, 100-240V AC 50/60Hz, Output 5V/2A DC with 2.5*0.7mm Male DC Plug

11.  30cm male HDMI Cable to female HDMI

Note:  ODROID C1+/C2 computer is not included!